Publicité
Step 4
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the ENDS (A and B) until the shoulders of the SCREWS
rest on the surfaces of the ENDS.
Slide the END MOLDINGS (U) onto the ENDS (A and B).
å
Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the ENDS.
NOTE: The MOLDINGS should be centered on the ENDS.
å
B
Surface with grooves
Page 8
U
A
BLACK 9/16" FLAT HEAD SCREW
424988
Some assembly
(and snacks) required.
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Shoulder
U
32S
(4 used in this step)
www.sauder.com/service
Publicité
