Yakima QuickBack 2 Mode D'emploi page 3

Attach top hooks.
Attach both top strap hooks (labeled TOP) around top edge
of the Trunk Lid, hatch lid, or rear door. They should be
parallel, and no wider then the body of the QuickBack.
WARNING: DO NOT ATTACH THE UPPER HOOKS TO GLASS, PLASTIC, OR
SPOILERS! USE THE GLASS HATCH ADAPTERS. USE OF THE GLASS HATCH
Replacing UppeR StRap HookS witH
glaSS HatcH adapteRS
A
PULL EXISTING
UPPER STRAPS
COMPLETELY
OUT OF THE
BUCKLES.
B
OPEN THE
HATCH
DOOR.
1033626B-3/24
ADAPTERS WILL LIMIT THE LOAD TO TWO BIKES ONLY.
Follow Glass Hatch Adapter installation instructions below.
Straps should be routed
over the frame.
Adjust both straps by pulling on free ends
of straps toward top hooks, or by pressing
Note: Leave straps slightly loose. Straps
No glass or plastic? You won't need the
Glass Hatch Adapters, continue to STEP 5.
Pass the Glass Hatch Adapter
strap ends through the hatch
opening from inside the
vehicle.
Keep the pads away
from the door's edge.
the release buttons on the buckles.
WARNING: Do not pull upper straps
sideways! PULL TOWARD THE VEHICLE!
will be fully tightened in a later step.