Heath Zenith DualBrite SL-4290 Serie Mode D'emploi page 2

Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes,
turn the power off for one minute, then back
on. After the calibration time the control will
be in the AUTO mode.
®
D B
ual rite
Light comes on half bright for selected time
after dusk (Off, 3 hr., 6 hr., until dawn).
Selecting OFF disables this feature. The
motion sensing features will continue to
work as described in this manual. If motion
is sensed, the light turns on full bright for the
ON-TIME (1, 5, or 10 minutes) then returns
to dim mode.
iNStallatiON
Estimated Installation Time: 30 minutes
Items needed for installation (not included):
• Phillips and flathead screwdrivers
• Pliers
• Safety glasses • Light bulb
• Silicone caulk
For best performance, mount the fixture about
6 feet (1.8 m) above the ground.
WARNING: Turn power off at circuit
breaker or fuse.
ON-TIME Switch at 1,
5, or 10 minutes
Flip light switch
off for one second
then back on*
Dimmer Control
• Wire strippers/cutters
5. Attach X-Bar to
junction box
Due to the size and weight of the fixture, you
may find it helpful to have an assistant hold the
fixture in place while connecting the wires.
2
1. Remove 2. Remove
two nuts. X-Bar.
3. Tighten screws
finger tight.
SENSITIVITY
MIN
4. Set sensitivity on fixture
back to the mid-position.
Junction
Box
598-1277-01
MAX