Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
16. Line Out - Pre Effects (XLR)
The Line Out is a balanced mono signal that combines Channel 1 and 2, but pre-effects (i.e. this signal does not contain
the Standard's onboard effects). You can use this output to directly connect to a mixer, or PA system. Please note that the
Master control does not affect the line out level, however the Volume and Tone controls of Channels 1 and 2 do.
17. Ground Lift Switch
The ground lift switch can be used for both pre and post EFX line outs to reduce any ground hum. This switch is
located at the back of the unit besides the XLR line out.
Power @ min. impedance (Watts)
Speaker Configuration - LF (Size / Power)
Speaker Configuration - HF (Size / Power)
Line Out (type / configuration)
Effects Footswitch / Function
Specifications - English
Specifications
Burst Power - 2 cycle
Input Channels
Channel 1 - inputs
Channel 1 - controls
Digital effects
Channel 2 - inputs
Channel 2 - controls
Digital effects
Aux input
Master Volume Control
Input Sensitivity (mV)
Line Out Sensitivity (Vrms)
Ground lift
Effects Loop / Location
LED Indicators
Dimensions (DWH, inches)
Dimensions (DWH, cm)
Weight (lbs / kg)
1/4-inch T.R.S.
Phone Plug
Tip = 0°
Ring = 180°
Sleeve = Ground
3
150
160
2x 6.5 inch / 75 Watts each
2 X 1-inch Neo 8 ohm / 50 watt dome tweeter
2 + Aux input
1/4 inch TRS
Gain, Bass, Lo Mid,Hi Mid, Treble, Feedback Notch Filter
Mix, EFX select, EFX modify
16 modifiable digital effects
1/4 inch TRS, XLR Combi Jack
Gain, Bass, Treble, Mix, EFX select, EFX modify
16 modifiable digital effects
RCA, stereo
Yes
ch 1=100, ch 2=1V
Pre EFX XLR, Post EFX 2 X 1/4" stereo balanced
1
Switch located at the back for both line-outs.
Ch 1 & 2 mixed, at Rear.
Optional / Internal Effects Bypass for Ch 1 & 2
Power, Clip
12 x 19 x 14
30 x 48 x 36
27.5 / 12.5
XLR Plug
(Male)
Pin 1 = Ground
1
2
Pin 2 = 0°
3
Pin 3 = 180°
Balanced 1/4-inch T.R.S. to Balanced XLR
Publicité
Table des Matières
