Subaru H001SFJ400 Instructions D'installation page 6

REMOTE START CONTROL MODULE MOUNTING
7
1. Locate the vehicle's automatic transmission (A / T) module mounted to the
left side of the steering column. (FIGURE V)
2. Route the previously installed windshield mounted antenna harness and
previously installed remote start pre-fit jumper harness towards the A / T
module and plug into the corresponding connectors on the remote start
control module (FIGURE W). Route the remote start ignition harness,
under the steering column, towards the A / T module and plug into the
corresponding connector on the remote start control module (FIGURE W).
Double check all connectors to ensure a secure fit.
3. Secure the remote start control module to the left side of the A / T module
using the supplied velcro making sure the remote start ignition harness
connector is facing down (same direction as the A / T module connector).
(FIGURE X)
4. As a secondary mounting provision, secure the remote start control module
to the A / T module using the supplied 21" tie wrap (route the tie wrap
between the 12-pin and 5-pin connectors on the remote start control module
and through the right side of the A / T module bracket). (FIGURE X)
5. Using the supplied 8" tie wrap, secure excess remote start jumper harness
and antenna harness wiring to the existing vehicle wiring near the prefit
connectors behind the fusebox. (FIGURE Y)
6. Using the supplied 8" tie wrap, secure the remote start ignition harness to
the existing vehicle wiring near the prefit connectors behind the fusebox.
(FIGURE Y)
7. Using a supplied 8" reusable (heavier guage) tie wrap, secure the mated
remote start harness 8-pin male and vehicle's 8-pin female connectors to
the existing factory wiring harness located lower front of the steering column.
(FIGURE Z)
8. Route the remote start ignition harness down the right side of the steering
column. Ensure that the remote start harness is positioned on top of the
factory ignition harness. Secure the remote start harness to the factory
ignition harness in three (3) places using the supplied 8" tie wraps.
(FIGURE Z)
NOTE: After the remote start control module has been mounted and
all wiring secured, operate the tilt / telescopic fully to ensure that the
new components do not interfere with operation of the tilt / telescopic
feature.
PART NUMBER ISSUE
H001SFJ400
DATE
00
20 Apr 2013
A/T Module
Ignition Harness
Connector
A/T Module
Tie Wrap
SUBARU OF AMERICA
Brake Pedal
FIGURE V
Antenna Harness
Jumper Harness
Connector
Connector
FIGURE W
Brake Pedal
FIGURE X
Tie Wraps
FIGURE Z
6 OF 10