Subaru H001SFJ400 Instructions D'installation page 4

WINDSHIELD MOUNT ANTENNA INSTALLATION, continued
5
ANTENNA POD MOUNTING / HARNESS ROUTING
1. Plug the 5-pin connector on the antenna harness into the 5-
pin port on the antenna pod. (FIGURE M)
2. Wrap one (1) piece of the supplied foam tape around the
antenna harness 3" from the connector and a second piece
6" away from the first piece of foam tape. (FIGURE M)
3. Locate the position at the top of the windshield 1" left of
center and 1" down from the headliner. Use alcohol to clean
the area thoroughly.
4. Remove the adhesive backing on the antenna pod and apply
the antenna to the windshield in the area indicated above.
Note the base of the antenna pod (harness connection end)
should line up to the area of the windshield where the solid
black film and dotted black film meet. (FIGURE N)
5. Route the antenna harness across the headliner and down
the A-pillar tucking the cable below the driver's side
dashboard through the opening closest to the windshield
and allow the harness to hang loose behind the vehicle's
dashboard mounted fusebox. (FIGURE O) The antenna
harness will be plugged into the remote start control module
later.
6. Secure the antenna harness to the existing vehicle wiring in
the A-pillar in three (3) places using the supplied 8" tie wraps.
Wrap the tie wraps with the supplied foam tape to prevent
rattling. (FIGURE P)
7. Install the supplied A-pillar trim clip and re-install the A-
pillar panel. (FIGURE Q)
8. Re-install the driver's side dashboard tweeter cover.
FIGURE P
PART NUMBER ISSUE
H001SFJ400
DATE
00
20 Apr 2013
3"
FIGURE M
FIGURE N
FIGURE Q
SUBARU OF AMERICA
6"
FIGURE O
4 OF 10