Subaru H001SFJ400 Instructions D'installation page 5

6
MAIN HARNESS CONNECTIONS
NOTE: Use caution while installing the wiring harness, be sure to
route and attach the harness away from sharp metal surfaces.
6-PIN IGNITION SWITCH CONNECTIONS
1. Adjust the tilt/telescoping steering column all the way out and down.
2. Locate the 8-pin ignition switch connector on the right side of the steering
column and unplug. Carefully pull the connector down and toward the steering
wheel. (FIGURE R)
3. Plug the remote start ignition harness 8-pin female connector into the vehicle's
ignition switch. (FIGURE S)
4. Route the remote start harness over the factory harness, toward the vehicle
fire wall. (FIGURE S)
5. Carefully fold back the remote start harness 8-pin male connector. Plug the
previously unplugged vehicle's female ignition switch connector into the remote
start ignition harness 8-pin male connector (FIGURE S).
4-PIN & 2-PIN PRE-FIT CONNECTIONS LEFT CENTER of STEERING COLUMN
1. Locate the vehicle's 4-pin and 2-pin pre-fit connections located to the left
center of the steering column located near the left side lower dashboard
airbag / knee bolster mount. These connectors are secured to the vehicle
wiring using breakaway tape. (FIGURE T)
2. When the 2-pin pre-fit connector is located, unplug and discard the mating
wire jumper. (This is used for the power window interrupt circuit)
3. Plug the remote start pre-fit jumper harness 4-pin and 2-pin male connectors
into the corresponding 4-pin and 2-pin vehicle female connectors.
(FIGURE U)
PART NUMBER ISSUE
H001SFJ400
DATE
00
20 Apr 2013
SUBARU OF AMERICA
5 OF 10