Disc Playback - Yamaha RDX-E700 Mode D'emploi

TROUBLESHOOTING

Disc playback

Problem
Some button operations do
not work.
Playback does not start
immediately when pressing
h.
An audio or subtitle
language does not switch.
No subtitles appear.
A viewing angle does not
switch.
DVD videos cannot be
copied with the VCR.
Picture looks poor.
The TV (monitor) does not
show the picture properly.
The screen size of the TV
(monitor) looks strange.
The TV shows overlapped
picture partly.
The disc is ejected without
an operation.
The message "No Disc"
appears in the DVD receiver
display even though a disc
is inserted.
46
Cause
Some discs do not support certain
DVD receiver functions.
The disc may not be set in the disc
tray properly.
The disc may be dirty.
The disc loaded into the DVD receiver
may be not compatible.
When moved the DVD receiver from
a cold place to warm one,
condensation may be form on the
disc reading lens.
The disc may not support the multi-
language feature.
The subtitle may be set to "Off".
The disc may not contain subtitle
data.
When using the A-B Repeat function,
the subtitle may not appear at the
parts other than the selected section.
The disc may not support the
multi-angle feature.
You may be trying to copy a
copy-protected DVD.
In some cases, picture may look poor
while fast forwarding or reversing,
but this is not a defect.
The picture settings may be
improper.
The Progressive Scan mode may be
used with a TV that does not support it.
The picture settings may be
improper.
When the Progressive Scan mode is
activated, image with a 4:3 aspect
ratio are played on a 16:9 wide
television screen.
The disc content does not match the
Progressive Scan mode due to the
editing method or other conditions.
The disc loaded into the DVD receiver
may be not compatible.
The disc may not be set in the disc
tray.
Solution
Set the disc in the disc tray properly.
Wipe the disc clean.
Make sure you use a disc supported by
the DVD receiver (page 21).
Wait for one to two hours, then try
again.
Make sure you use a disc that supports
the multi-language feature.
Select a subtitle language you want to
display (page 28).
Make sure you use a disc with subtitle
data.
Cancel the A-B Repeat function
(page 26).
Make sure you use a disc that supports
the multi-angle feature.
Most commercially available DVDs
include copy protect features. You
cannot make a copy of these DVDs.
Adjust the picture settings with the
OSD menu (page 19).
Turn off the Progressive Scan mode
(page 31).
Adjust the picture settings with the
OSD menu (page 19).
Change "TV TYPE" with the OSD
menu (page 19).
If you cannot adjust the ratio, turn off
the Progressive Scan mode and use the
interlace output mode (page 31).
Turn off the Progressive Scan mode
(page 31).
Make sure you use a disc supported by
the DVD receiver (page 21).
Set the disc in the disc tray properly.