Turning The Power To On/Standby; Selecting An Input Source - Yamaha RDX-E700 Mode D'emploi

TURNING THE POWER TO ON/STANDBY

TURNING THE POWER TO ON/STANDBY
STANDBY/ON (
You can enjoy various sources with the DVD receiver. After connecting the TV, speakers, antennas, or other equipment,
follow the procedure below to select an input source you want to play on the DVD receiver. For information on
connection methods, refer to pages 8 to 12.
TV VOL
+
–
EQ
TV
DIRECT
AUX
SUBTITLE ANGLE
Perform one of the following operations
To switch to DVD/CD input:
Press DVD/CD.
To switch to external source input (external
equipment connected to the DVD receiver):
Press AUX.
To switch to TV input:
Press TV.
U.K. and Europe models only
You can switch the input signals between signals
input at the TV IN jacks and signals input at AV
terminal (page 20).
To switch to tuner input (AM/FM radio):
Press TUNER.
Each time you press TUNER, the input source
switches between AM and FM.
14
STANDBY/ON
POWER
)
TV
1 2 3 4
5 6 7 8
DIMMER SLEEP
9 0
+
A-B
REPEAT
TV CH

SELECTING AN INPUT SOURCE

VOLUME
MUTE
+
–
NIGHT
TV DVD/CD
DVD/CD
AUX TUNER
TUNER
ZOOM AUDIO
Press STANDBY/ON once to turn on the DVD
receiver.
Press STANDBY/ON again to set the DVD
receiver to the standby mode.
y
You can set the DVD receiver to the eco standby mode by
pressing DISPLAY on the front panel during standby mode. In
this mode, all display in the DVD receiver turns off. To cancel the
eco standby mode, press DISPLAY during eco mode.
■ To select an input source using INPUT
on the front panel
Press INPUT repeatedly.
Each time you press INPUT, the input source changes as
follows:
DVD/CD
TV/SCART*
*
SCART is applicable only for U.K and Europe models.
FM
AM
AUX