Connecting A Subwoofer - Yamaha RDX-E700 Mode D'emploi

CONNECTING SPEAKERS
Connecting speakers
1
Remove approximately 10 mm (3/8 in) of
insulation from the end of each speaker
cable and twist the exposed wires of the
cable together to prevent short circuits.
10 mm (3/8 in)
2
Press and hold the lever.
3
Insert one bare wire. By releasing the lever,
the lever is replaced.
■ Notes on the speaker cord
A speaker cord is actually a pair of insulated cables
running side by side. One cable is colored or shaped
differently, perhaps with a stripe, groove or ridge. Connect
the striped (grooved, etc.) cable to the "+" (red) terminals
on the DVD receiver and your speaker. Connect the plain
cable to the "–" (black) terminals on the DVD receiver
and your speaker.
8
Red: positive (+)
Black: negative (–)
Red: positive (+)
Black: negative (–)

Connecting a subwoofer

Connect the SUBWOOFER OUT jack on the DVD
receiver to the INPUT jack on the subwoofer
using the subwoofer cable.
SPEAKERS SUB WOOFER
OUT
R L
6Ω MIN. /SPEAKER
Subwoofer cable
INPUT
INPUT
Subwoofer
Notes
• Do not connect the power cable of the DVD receiver or
subwoofer until all cable connections are completed.
• The low frequency range of the downmixed sound is output at
the SUBWOOFER OUT jack.