Electronic Ignition & Automatic Reignition; Surface Burners - Monogram ZGU36RS Manuel D'utilisation

USING THE COOKTOP
ELECTRONIC IGNITION & AUTOMATIC REIGNITION
The cooktop is equipped with electronic ignition which
eliminates the need for a standing pilot light.
The burners on this cooktop will automatically relight if the
flame goes out.
All surface burner igniters will spark and make clicking
sounds when any burner is turned on. Do not touch any of
the burners when igniters are clicking.
Occasionally the burners may spark if excess wind or a
draft blows the flame away from the burner's flame sensor.

SURFACE BURNERS

Lighting a Surface Burner
Push the control knob down and turn it counterclockwise
to the LITE position.
WARNING
Burners should be operated only when
covered by cookware. Burner flames not covered by
cookware present a risk of fire or clothing ignition.
Never let flames extend beyond the sides of the
cookware. Failure to comply may result in serious
injury.
Dual-flame Stacked Burners
Some surface burners on your cooktop have two sets of
flames stacked one on top of the other; the dual-flame
burners have a lower (simmer) flame and a upper (main)
flame.
When a burner is turned on, the lower flame will always
light and stay on.
Simmering:
The stacked burner design provides a wide cooktop of
heat settings with which to simmer. Depending on the
type and quantity of food, and pan size, the flame can be
adjusted to suit your specific need. The lowest setting uses
only the lower flame and can maintain delicate foods at a
safe 140°F.
Multi-Ring Burner
For large cookware, activate all rings by setting the burner
between Hi and Med.
49-2001105 Rev. 0
In case of a power outage, you can light the surface
burners on your cooktop with a match. Hold a lighted match
to the burner, then turn the knob to the LITE position. Use
extreme caution when lighting burners this way.
After the burner ignites, turn the knob to adjust the flame
size.
To turn a burner off, turn the knob clockwise, as far as it
will go, to the OFF position.
Do not operate a burner for an
■
extended period of time without
cookware on the grate. The finish on
the grate may chip without cookware
to absorb the heat.
Cooking:
Settings from LO to HI will use both upper and lower
flames. Use LO to HI for all purpose cooking. Use HI with
larger diameter cookware.
HI is a very high heat setting and is intended to sear foods
quickly and boil large quantities of water.
For small cookware or low heating applications, only
activate the inner rings by setting the burner between Lo
and Sim.
Push the control knob
in and turn it to the
LITE position.
Lower
Flame
Upper Flame
Lower Flame
9