Dust Collector Attatchment; Removing The Spline Shaft; Changing The Brushes; Lubrication And Cleaning - Virutex FC116U Mode D'emploi

D2
D1
Gt
E
Gp
(Figure 25)
L
E
M
(Figure 26)
H1
I1
(Figure 27)
30 - FC116U / Operating instructions

17. DUST COLLECTOR ATTATCHMENT

• The FC116U mortising trimmer is equipped with a nozzle, "D2"
(Fig. 24) which, when mounted on the position bar "D1" (Fig. 24)
over the opening of the box to be made, allows the connection
of the Virutex AS182K, AS282K, AS382L and ASC482U dust co-
llector or another Industrial Dust Collector for the collection of
trimming chips
(Figure 24)

18. REMOVING THE SPLINE SHAFT

In order to change the spline shaft "M" (Fig. 26), first dismount
the bit "G" (Fig. 25) as explained in section 6.
Place the lock pin "L" (Fig. 26) in the central aperture of the
chassis until the motor axis is locked and remove the spline shaft
"M" with the key "E".
F
G

19. CHANGING THE BRUSHES

• The brushes should be changed when they are a minimum of
5 mm long. To do this, dismount the switch box "F1" (Fig. 27),
removing the screws "G1" which fasten it.
Remove the plugs "H1" which fasten the brushes "I1" and re-
place with new original VIRUTEX ones, checking that they slide
smoothly on the inside of the guides. Ensure when mounting the
switch box "F1" again that the cables are properly positioned
inside. It is advisable to leave the machine running for a few mi-
nutes after a change of brushes. Take advantage of the change
of brushes to check the state of the collector. If this shows signs
of burns or wear and tear, it is advisable to take it to VIRUTEX
technical service for repair.
I1
H1

20. LUBRICATION AND CLEANING

F1
• Before trimming the first fitting, lubricate the depth guide
columns "Gp" (Fig. 25) and side columns "Gt" (Fig. 25), with a
lightly oiled cloth, in order to smooth the two movements. It is
G1
important always to clean the machine carefully after use, with
a dry air jet.
Always keep the power supply cable in perfect condition.
Make sure that the machine is disconnected
from the mains before any handling is done.