Trimming The Fitting - Virutex FC116U Mode D'emploi

K
W
A
J
(Figure 15.2)
(Figure 16.2)
Z
Y
A
S1
(Figure 18.2)

TRIMMING THE FITTING

• Check that the lock lever "J" (Fig. 15.2) is in the horizontal
position (advance depth disconnected).
Trimming the top of the fitting:
• Manually turn the tool until it is in a vertical position (Fig.
16.2).
• Turn the handle "A" (Fig. 15.2) clockwise (+) as far as the top
stop "S1" (Fig. 15.2) and make sure it is kept in this position.
• Release the machine from the door edge and move it over the
edge vertically until the top edge of the tool coincides with the
S1
top mark on the front of the lock (Fig. 16.2) and once again fix
the machine on the edge in this position.
• Connect the machine to the mains, switch on the motor, pres-
sing the lever "Y" (Fig. 18.2) and set the safety "Z" (Fig. 18.2).
• Turn the knob "W" (Fig. 18.2) until the motor support touches
depth stop "S3" (Fig. 18.2). When the tool reaches the depth of
cut planned for the front of the lock, move the carriage advance
handle "A" (Figs. 15.2 and 18.2) gently as far as lower stop "S1"
(Fig. 15.2).
If the fitting to be created is greater than 2 mm, it is advisable to
complete this process using two or three successive movements,
repeatedly using knob "W".
Trimming the bottom of the fitting:
• Manually turn the tool until it is in a vertical position (Fig.
16.2).
• Turn the handle "A" (Fig. 15.2) anticlockwise (-) as far as the
lower stop "S1" (Fig. 15.2) and make sure it is kept in this po-
sition.
• Release the machine from the door edge and move it over the
edge vertically until the bottom edge of the tool coincides with
the bottom mark on the front of the lock and once again fix the
machine on the edge in this position.
• Connect the machine to the mains, switch on the motor, pres-
sing the lever "Y" (Fig. 18.2) and set the safety "Z" (Fig. 18.2).
• Turn the knob "W" (Fig. 18.2) until the motor support touches
depth stop "S3" (Fig. 18.2). When the tool reaches the depth of
cut planned for the front of the lock, move the carriage advance
handle "A" (Figs. 15.2 and 18.2) upwards gently as far as top stop
"S1" (Fig. 15.2).
If the fitting to be created is greater than 2 mm, it is advisable to
complete this process using two or three successive movements,
W
repeatedly using knob "W".
• Return the knob "W" and the depth stop "S3" (Fig. 18.2) to
their initial position once the trim has been completed.
S3
FC116U / Operating instructions - 27