Correct Disposal Of This Product - ECOVACS ROBOTICS DEEBOT OZMO905 Manuel D'instructions

To satisfy RF exposure requirements, a separation
distance of 20 cm or more should be maintained
between this device and persons during device
operation.
To ensure compliance, operations at closer than
this distance is not recommended. The antenna
used for this transmitter must not be co-located in
conjunction with any other antenna or transmitter.
To disable Wi-Fi module on DEEBOT, power the
robot ON.
Place the robot on the Docking Station making
sure the Charging Contacts on DEEBOT and the
Docking Station Pins make a connection.
Press and hold the AUTO Mode Button on the
robot for 20 seconds until DEEBOT emits 3 beeps.
To enable Wi-Fi module on DEEBOT, power the
robot OFF and then power ON. The Wi- Fi module
is turned on when DEEBOT is restarted.
Class II
Short-circuit-proof safety isolating
transformer
Switch mode power supply
For indoor use only
1. Important Safety Instructions
For EU Countries
For EU Declaration of Conformity information,
visit https://www.ecovacs.com/global/compliance

Correct Disposal of this Product

This marking indicates that this product should
not be disposed of with other household
waste throughout the EU. To prevent possible
harm to the environment or human health
from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse
of material resources. To recycle your used
device, please use the return and collection
systems or contact the retailer where the
product was purchased. They can safely
recycle this product.
7
EN