ABC Design Zoom Instructions De Service page 11

7. Fitting and removing the guard rail
Fit the guard rail by inserting it in the plastic mounts on both sides.
To remove the guard rail from the pushchair, press in the buttons on both sides and pull the guard rail off
away from the pushchair.
8. Adjusting the leg rest
To adjust the leg rest, press in the buttons on both sides and then adjust the height.
Let go of the buttons again so that the leg rest clicks into place.
9. Fastening the harness
To fasten the harness, bring the top two plastic catches together and interlock them.
Then insert the interlocked catches into the bottom part of the fastening.
Adjust the harness to a setting where the baby is held in the correct position.
10. Unfastening the harness
To open the harness, press the button on the side.
CAUTION: Always use the shoulder harness and lap belt together.
11. Adjusting the seat unit
To adjust the seat unit, pull the retainer on the rear of the backrest upwards and then adjust the height of
the seat. When you have reached the required position, let go of the retainer to allow the seat to remain in
that position.
12. Adjusting the handle
Push the button upwards to adjust the height of the handle.
When the handle is at the required height, let go of the button again so that the handle will remain locked in
this position.
13. Folding the pushchair
NB: Remove the seat unit or carrycot before attempting to fold the pushchair.
Pull the two release catches on the left and right sides of the handlebar up.
Now use your foot to release the second catch which is on the left-hand rear wheel.
You can now fold down the push-bar.
Note: To unfold the pushchair, follow the instructions in point 1 "Opening the pushchair".
14. Adjusting the sun canopy
a. Pull the sun canopy out from inside the hood.
b. Fold the bottom half of the sun canopy up to reduce the shading a little.
EN - 06