Horizon Global 76928 Instructions D'installation page 9

5. Trim tab – Using tin snips trim metal tab as shown in Figure 2.
6. Install Hitch - NOTE: Apply blue thread locker to all fasteners. Raise the hitch into position. Loosely tighten M12 flange hex nuts to end panel. Then loosely attach
bolt on brackets using 7/16" conical washers ② and nuts ③ onto the carriage bolts ①, See Figure 1. Loosely install (4) M12 bolts ④, (2) ½ flat washer ⑥ , (2) ½"
lock washer ⑤ and (2) ½" conical washers (teeth side toward frame rail) ⑦ into existing weldnuts on the frame rail (2 per side).
7. Tighten all M10-1.25 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M), 7/16-14 fasteners to 50 Lb-ft. (68 N*M) and M12 fasteners to 68 Lb-ft. (92 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Figure 2
8. Modify kick sensor – Using a flat head screwdriver remove (3) push rivets from kick sensor. Using a Philips screwdriver remove (3) screws from the kick sensor and
disconnect it. Using a pair of pliers remove clips shown in Figure 3. Pull the wires back, secure with tape, and trim kick sensor as recommended in Figure 3. Reconnect
kick sensor to vehicle using (1) screw and (1) push rivet after modification. NOTE: DO NOT TRIM OR CUT ANY WIRES.
©2022 Horizon Global Americas Inc. - Printed in Mexico Sheet 9 of 30 76928NP 8/15/22 Rev. A