Horizon Global 76928 Instructions D'installation page 8

2f.) Using a plastic trim tool, starting at the outer ends near wheel well,
carefully remove the fascia by gently pulling rearward while releasing the clips
holding the fascia.
3. Remove frame plugs – Using a flat head screwdriver, remove (2) rearmost
thread plugs from driver side frame rail. Repeat for opposite side.
©2022 Horizon Global Americas Inc. - Printed in Mexico
2g.) If equipped, disconnect all wiring harnesses from fascia and carefully set
fascia aside.
4. Remove bumper beam – Remove tape from bumper beam. Using a 14mm
socket with extension, remove (6) flange hex nuts. Keep hex flange nuts for
hitch installation. Return bumper beam to vehicle owner. See Figure 1.
Sheet 8 of 30 76928NP 8/15/22 Rev. A