Publicité
Step 17
Insert the dowel end of two TWIST-LOCK® FASTENERS (7F) into the
å
419600 Left End as shown in the enlarged diagram.
NOTE: If you already pushed TWIST-LOCK® FASTENERS into
å
the holes in the RIGHT END (A), pull the FASTENERS back out
of the holes. Pull at the front and back edges, slowly working the
FASTENERS out of the holes.
Push the RIGHT END (A) onto the TWIST-LOCK® FASTENERS in the
å
419600 Left End. Now, tighten four TWIST-LOCK® FASTENERS.
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
www.sauder.com/services
L-Shape Assembly
A
Finished edge
®
FASTENER
419600 Top
419600
Left End
Dowel end
419594
Page 21
Publicité
