Ega Master 63083 Manuel D'instructions page 9

Problem:
- The material chosen for cutting, is not adequate.
Solution:
- Cut only recommended materials PP, PVC, PPR, PEX-A, PEX-B, PEX-C, KEVLAR and multilayer plastic.
Problem:
- The safety button (6) is not pressed.
Solution:
- Make sure for cutting that this safety button (6) is pressed.
Problem:
- The blade does not cut well.
Solution:
- The blade needs to be sharpened.
- Replace the blade.
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the machine
being incorrectly used or, applied for a purpose for which it was not intended.
For ordering spare parts, please refer to the Spare Parts Drawing and note the needed number.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones must
be collected and arranged separately. If you have to throw them out, please, do not use the usual
rubbish. Please, contact your distributor for free recycling.
The maker guarantees to the machine owner 12 months against any manifacture defect.
This guaranteee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly filled
within one week after purchased the machine to the maker.
NOTES
GUARANTEE
9