Ega Master 63083 Manuel D'instructions page 7

1. Electrical cable connector.
2. Handle.
3. Safety switch.
4. Blade returning button.
5. ON / OFF switch.
6. Safety button.
7. Blade.
Before starting working, verify the integrity of all the components.
1. Plug in the supplied adapter to charge the battery. Once the charging is completed remove the
adapter and the cutter is ready for use.
2. Place the ON / OFF switch to ON position.
3. Place the pipe into the pipe support of the cutter and the safety button will be pushed.
4. Press the safety switch and the cutter will start cutting.
5. After cutting the pipe, release the safety switch and press the return button. The blade will go
back to its starting position and the cutter will be ready for a new cut.
6. If you are not going to make more cuts, place the ON / OFF switch to OFF position.
1
4
ELECTRIC PIPE CUTTER PARTS
OPERATING INSTRUCTION
2
5
2
3
1
3
6
4
7
6
5
7