Publicité
Les langues disponibles
Les langues disponibles
2
b. Remove the 5/16" Allen Screw with a 1/4" Allen
Wrench. The 5/16" Allen Screw is located on the
opposite end of the mount from the hinge that
opens and closes when the mount is stowed and
deployed.
c. Once the Allen Screw and Lock Washer are
removed, lift the Bowguard/Steering Module
straight up until it is free from the mount.
Cable and Handle Installation
1
ITEM(S) NEEDED
B x 1
a. Once the Bowguard/Steering Module is removed
note how the rope is routed through the mount,
Rope Guide, around the Pin, and into Latch/Strap
Rope Pull Bracket. The new cable will be routed
in the same manner.
b. Remove the current rope.
c. Taking the new Cable and Handle (Item B), feed
the new Cable End Stop down through the top
Rope Guide hole, around the Lower Pin, and feed
the Cable through the Latch/Strap Rope Pull
Bracket. Pull the Cable through and out one of
the cutout windows in the aluminum arm. This
will allow room to attach the Clevis.
©2016 Johnson Outdoors Marine Electronics, Inc.
Allen Screw with Lock Washer
Latch/Strap Rope
Pull Bracket
Cable
Aluminum Arm
Rope Guide
Cable End
Stop
Latch/Strap Rope
Pull Bracket
minnkotamotors.com | 3
Publicité
