Publicité
Les langues disponibles
Les langues disponibles
2
b. To disconnect the Gas Spring, locate the Upper
Cylinder Pin. Two Phillips Screws hold the Upper
Cylinder for the Gas Spring in place. Using two #3
Phillips screwdrivers, hold the screw at one end
of the Upper Cylinder Pin in place.
c. Remove the screw at the opposite end of the pin
with the other #3 Phillips screwdriver.
WARNING
The gas assist lift mechanism in this unit is under high spring
pressure when the motor is in the deployed position. Do not
remove the Steering Module assembly from the mount without
disconnecting one end of the gas spring. Failure to do this
can create a condition where accidental pulling of the pull grip
and rope may cause the mount to spring open rapidly, striking
anyone or anything in the direct path.
3
d. Once the screws are removed, the pin and
spacers can be removed from the Upper Cylinder.
e. Now it is safe to remove the motor from the
bow mount when the motor is in the deployed
position.
Remove Motor From Mount
1
WARNING
Moving parts can cut or crush. The gas assist lift
mechanism is under pressure. Disconnect gas
spring before removing motor from mount. Do not
engage the pull grip and rope until gas spring is
disconnected.
a. With the gas spring disconnected, place the
motor in the deployed position.
©2016 Johnson Outdoors Marine Electronics, Inc.
Upper
Gas Spring
Cylinder Pin
Cylinder
Spacer
Outer Arm
Spacer
Outer Arm
Phillips Screw
NOTE:
Use a #3 Philips screwdriver to remove the
screws. They have a pre-applied thread locker. Not
using the recommended tool can cause damage and
prevent them from being removed.
Outer Arm
Gas Spring Cylinder
Outer Arm
Phillips Screw
Outer Arm
Spacers
Outer Arm
Gas Spring
Phillips Screw
Cylinder
minnkotamotors.com | 2
Publicité
