Publicité
Les langues disponibles
Les langues disponibles
2
d. Reinstall the 5/16" Allen Screw and Lock Washer
and tighten to 18 to 20 ft-lbs with a Torque
Wrench.
e. Position the motor to the stowed position using
the pull grip and rope to disengage the latch bar,
allowing the motor to fold into a flat position.
3
f.
Once in the stowed or flat position, the gas spring
and spacers can be installed.
g. Locate the upper gas spring pin and spacers.
h. Align the end of the Gas Spring with the holes in
the outer arm of the base.
4
i.
Align the Pin with one spacer on each side of the
Cylinder for the Gas Spring, so that is passes
through one side of the outer arm, a spacer, the
Cylinder of the Gas Spring, then an additional
spacer and finally through the outer arm at the
other side of the base.
j.
The Pin should be secured on each end with a
screw. Hold one screw in place with a #3 Phillips
screwdriver and secure the other screw with an
additional #3 Phillips screwdriver.
k. Tighten screws until the heads are flush with the
outer arm.
NOTE:
Screws have a pre-applied thread locker.
DO NOT apply additional thread-locker to the
screws as it may prevent future removal.
©2016 Johnson Outdoors Marine Electronics, Inc.
Allen Screw with Lock Washer
Outer Arm
Proper Alignment
Outer Arm
Gas Spring Cylinder
Phillips Screw
Gas Spring Pin
Outer Arm
Spacer
Outer Arm
Gas Spring
Spacer
Cylinder
Phillips Screw
Gas Spring
Cylinder
Outer Arm
Spacer
Spacer
Outer Arm
Phillips Screw
minnkotamotors.com | 5
Publicité
