Publicité
Les langues disponibles
Les langues disponibles
2
ITEM(S) NEEDED
#10 x 1
d. Attach the Clevis (Item #8) onto the Cable by
sliding the clevis slot over the cable and sliding
the Cable End Stop into the Clevis. Install the
Clevis Pin and Retaining Ring (Item #10). The
Clevis Pin must be installed to prevent the Cable
from coming out of the Clevis.
3
e. Pull on the Cable Handle until the Clevis slides
into the opening between the Latch Bar and
Latch/Strap Rope Pull Bracket.
Reassemble the Bowguard/Steering Module
1
a. To reassemble the Bowguard/Steering Module,
start with the mount in the deployed position.
b. Align the Keyways on the inside of the
Bowguard/Steering Module with the End
Links on the mount. Do this by positioning the
Bowguard/Steering Module above the End Links
on the mount.
c. Lower the Bowguard/Steering Module straight
down until seated.
©2016 Johnson Outdoors Marine Electronics, Inc.
#8 x 1
Cable End Stop
Clevis Pin and
Retaining Ring
Cable
Clevis
Clevis Pin
Rope Guide
Latch/Strap Rope
Pull Bracket
Latch Bar
Keyways
End Links
minnkotamotors.com | 4
Publicité
