Publicité
Les langues disponibles
Les langues disponibles
EDGE AND RIPTIDE EDGE INSTALLATION
1
ITEM(S) NEEDED
B x 1
a. Note how the rope is routed through the Rope
Guide, around Lower Arm Pin, and into the Latch/
Strap Rope Pull Bracket. The new cable will be
routed in the same manner.
b. Remove the current rope.
c. Take the new Cable and Handle (Item B) and
feed the Cable End Stop down through top Rope
Guide, around the Lower Arm Pin, and slide down
the inside of the Lower Arm. Looking through the
hole in the underside of Lower Arm, use a Needle
Nose Pliers or similar tool to grasp the Cable End
Stop and pull it out through the hole a few inches.
This will allow room to attach the Clevis.
2
ITEM(S) NEEDED
#10 x 1
d. Attach the Clevis (Item #8) to the Cable by sliding
the clevis slot over the Cable and sliding the
Cable End Stop into the Clevis.
e. Pull on the cable handle until the Clevis slides into
the hole in the Lower Arm.
f.
Using a Needle Nose Pliers or similar tool insert
the Clevis Pin and Retaining Ring (Item #10)
through the slot in the side of the Lower Arm, into
Clevis, through the hole in Latch/Strap Rope Pull
Bracket and out the opposite side of the Clevis.
Install Retaining Ring onto the groove of the
Clevis Pin.
For warranty information please visit
minnkotamotors.com
Part #2374950
#8 x 1
minnkotamotors.com
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
Lower
Arm Hole
Cable
End Stop
Needle
Nose
Pliers
Lower
Arm
Latch/Strap
Rope Pull
Bracket
Cable
Clevis
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
ECN 39004
Lower
Arm Pin
Latch/Strap
Rope Pull
Bracket
Cable
Cable
End Stop
Clevis
Needle
Nose
Pliers
Clevis
Pin and
Retaining
Ring
A Johnson Outdoors Company
©2016 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Rev C
03/18
Publicité
