Error Codes - Signature SDW6001A+ Instructions D'utilisation

Problem
The dishes
are not clean
Unsatis
-factory
washing
result
Cloudiness
on glassware
Black or gray
marks on dishes
Detergent left in
dispenser cups
The dishes
are not drying
Unsatis
-factory
drying
result

Error Codes

When some malfunctions come on, the appliance will display error codes to warn you:
Codes Meanings
The rapid light flicker
fleetly
The Rapid and 90Min
light flicker fleetly
The Glass light flicker
fleetly
WARNING!
1. If overflow occurs, turn off the main water supply before calling a service.
2. If there is water in the base pan because of an overfill or small leak, the water should be
removed before restarting the dishwasher.
Possible Causes
The dishes were not
loaded correctly.
The programme was
not powerful enough.
Not enough detergent
was dispensed.
Item are blocking
the path of spray arms.
The filter combination
in the base of wash
cabinet is not clean or
is not correctly fitted.
This may cause
the spray arm jets
get blocked.
Combination of soft
water and too much
detergent.
Aluminum utensils
have rubbed against
dishes.
Dishes block
detergent cup opens.
Improper loading
Too little rinse-aid
Dishes are removed
too soon.
Wrong programme
selection
Using cutlery with
a low-quality coating
Longer inlet time.
Not reaching required
temperature.
Overflow.
What To Do
See notes in " Loading the Dishwasher Baskets ".
Select a more intensive program.
See" Wash Cycle Table ".
Use more detergent, or change your detergent.
Rearrange the items so that the sprayer can rotate
freely.
Clean and/or fit the filter combination correctly.
Clean the spray arm jets. See "Cleaning the Spray
Arms".
Use less detergent if you have soft water and
select a shortest cycle to wash the glassware and
to get them clean.
Use a mild abrasive cleaner to eliminate those
marks.
Re-loading the dishes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/Refill the rinse-aid
dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam
can escape. Begin unloading the dishwasher only
once the dishes are barely warm by touching.
In short programmes the rinse temperature is lower.
Choose a program with a high rinse temperature.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
Possible Causes
Faucets is not opened, or water intake is restricted,
or water pressure is too low.
Malfunction of heating element .
Some element of dishwasher leaks .
-54-