Signature SDW6001A+ Instructions D'utilisation page 41

Step 2: select a certain level of salt consumption
Press the Start/pause button to select the proper set according to your local environment,
the sets will change in the following sequence: H1->H2->H3->H4->H5->H6;
Step 3: Exit the status of salt adjustment
Without any operation in five seconds, the machine will exit from set mode, the machine is into standby
status
There are 6 levels of salt consumption in all.It is recommended to select the level according to below table:
Water Hardness level
1)
dH
0-5
6-11
12-17
18-22
23-34
35-45
Note:
1) German degree of measurement for the water hardness
2) millimol, internationel unit for water hardness
*) factory setting
Contact your local water board for information on the hardness of your water supply.
B. Rinse Aid Dispenser
Rinse Aid Dispenser
The rinse aid is released during the final rinse to prevent water forming droplets on your dishes, which can leave
spots and streaks. It also improves drying by allowing water to roll off the dishes. Your dishwasher is designed to
use liquid rinse aids. The rinse aid dispenser is located inside the door next to the detergent dispenser. To fill the
dispenser, open the cap and pour the rinse aid into the dispenser until the level indicator turns completely black.
The volume of the rinse aid container is about 110ml.
Function of Rinse Aid
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, spot and streak free help the drying.
Setting on the
water softener
2)
mmol/l
0-0.9
1.0-2.0
2.1-3.0
3.1-4.0
4.1-6.1
6.2-8.0
-38-
Digital display stalls
Rapid
H1
1
H2 90Min
2
90Min
H3
3
Glass
H4
4*
5
Glass
H5
Glass
6 H6
& Rapid
& Rapid
& 90Min