Quick Operation Guide - Signature SDW6001A+ Instructions D'utilisation

For detailed operating method read the corresponding content on the instruction manual.
Switch on the
appliance
Fill the detergent
dispenser
Check the rinse
aid level
Check the
regeneration
salt level
Load the baskets
Select a
programme
Running the
dishwasher
Changing the
programme
Add forgotten
dishes in the
dishwasher.
If the appliance is
switched off
during a wash cycle.
Switch off the
appliance
Turn off the water
tap, unload the
baskets

Quick operation guide

Press the Power switch button to switch on the appliance,
Open the door.
Compartment A: For each wash cycle.
Compartment B: For programmes with pre-wash only.
(Follow the user instructions!)
Mechanical indicator C.
Electric indicator on control panel (if provided).
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill
the salt into the softener by the number of cycles
the dishwasher has run.
Scrape off any large food particles. Soften remnants of burnt food in
pans,then load the baskets. Refer to the dishwasher loading
instructions.
Close the door, Press the program button until the selected program
lights up.( See the section entitled"Operation instruction")
T urn on the water tap and press the Start/Pause button. The machine
will start working after about 10 seconds.
1. A running cycle can only be modified if it has been running for a
short time. Otherwise the detergent may have already been
released and the water already drained. If in this case, the
detergent dispenser must be refilled.
2. Press the Start/Pause button, then press the program button
more than 3 seconds to cancel
the running program.
3. Select a new program.
4. Restart the dishwasher.
1.Press the start/pause button to stop the machine.
2.Open the door.
3.Add the forgotten dishes.
4.Close the door, then press the start/pause button,
the dishwasher will start running again after 10 seconds.
If the appliance was switched off during a wash cycle, when
switched on again, please re-select the washing cycle and operate
the dishwasher from the beginning ).
When the working cycle is finished, the buzzer of the dishwasher will
sound 8 times, then stop.
Turn off the appliance using the Power button.
Since the appliance is standing by, it will power off automaticly after
30 minutes without any operation.
Warning: wait a few minutes (about 15 minutes) before unloading the
dishwasher to avoid scald, as the dishes and utensils are still hot and
more susceptible to break. They also could dry better.
-35-
A B
C
WARNING!
Open the door
carefully.
Hot steam may
escape when
the door is opened!