Suzuki LT-F400K3 Manuel D'assemblage page 16

Using multi circuit tester, measure the battery volt-
age. The tester should indicate more than 12.5–12.6
V (DC) as shown in the Fig. If the battery voltage is
lower than the specification, charge the battery with a
battery charger.
Recharging time:
6.0 A for one hour or 1.4 A for 5–10 hours
NOTE:
Initial charging for a new battery is recom-
mended if two years have elapsed since the
date of manufacture.
After filling the battery electrolyte or recharging the
battery, install the battery in the vehicle as follows.
!
When attaching the wiring harness battery
leads to the battery terminals, observe the cor-
rect polarity.
NOTE:
The terminal bolts and nuts are attached to the
battery.
1. Install the battery in place.
2. First connect the + + + + lead to the + + + + positive terminal
of the battery.
3. Cover + + + + terminal with rubber boot.
4. Connect the - - - - lead to the - - - - negative terminal of
the battery.
A: + lead
B: - lead
C: Rubber boot
Reinstall the bracket.
A: Bracket
B: Bolt
15