Accessories; Maintenance; Warranty - oventrop Multiblock TU Mode D'emploi

Illustr. 8 Conversion to one pipe operation
NOTICE
During one pipe operation, the flow via the bypass
is strongly limited while the isolating stem is
closed and the radiator is removed. In order to
guarantee the supply of the other radiators in the
one pipe circuit, the bridging fitting (item no.
1016452) has to be used.
6.5 Isolating
1. Remove thermostat.
2. Close thermostatic valve with the help of the
protection cap. Paragraph 6.2.1 "Advice regarding
protection cap" must be observed.
3. Remove cap from the isolation.
4. Close isolating stem by turning a 10 mm spanner
clockwise (see illustr. 9).
5. Refit cap.
Protection cap
Illustr. 9 Isolating

7 Accessories

Oventrop offers suitable straight and angle pattern
design covers for panelling.
Mount the design cover after installation has been
completed.
7.1 Installation of the straight pattern design
cover
Place both halves of the design cover around the
fitting and push them together until they click into
position (see illustr. 10). The correct positioning must
be observed (see marking inside the cover).
Conversion stem
Spanner size 4
Illustr. 10 Installation of the straight pattern design cover
7.2 Installation of the angle pattern design cover
1. Slip the design cover onto the fitting (see illustr.
2. In the end position, push the retaining flap
Isolating stem
Illustr. 11 Installation of the angle pattern design cover
Spanner size 10

8 Maintenance

The fitting is maintenance-free.
Tightness and function of the fitting and its connection
points have to be checked regularly during
maintenance. The fitting must be easily accessible.

9 Warranty

Oventrops warranty conditions valid at the time of
supply are applicable.
11).
upwards until it engages.
NOTICE
Installation of the design cover
To avoid damage to the design cover, it must only
be mounted after all building work has been
completed.
1
2
11