Operation; Safe Operating Precautions; Starting The Engine; Stopping The Engine - Honda GX630 Manuel De L'utilisateur

OPERATION

SAFE OPERATING PRECAUTIONS

Before operating the engine for the first time, please review the
SAFETY INFORMATION section on page 2 and the BEFORE
OPERATION CHECKS on page 3.
For your safety, do not operate the engine in an enclosed area such
as a garage. Your engine's exhaust contains poisonous carbon
monoxide gas that can collect rapidly in an enclosed area and
cause illness or death.
Exhaust contains poisonous carbon monoxide gas
that can build up to dangerous levels in closed areas.
Breathing carbon monoxide can cause
unconsciousness or death.
Never run the engine in a closed, or even partly closed
area where people may be present.
Review the instructions provided with the equipment powered by
this engine for any safety precautions that should be observed with
engine startup, shutdown, or operation.
Do not operate the engine on slopes greater than 20° (36%).

STARTING THE ENGINE

Refer to the instructions provided by the equipment manufacturer
for details on operating the engine switch and fuel valve.
1. Turn the fuel valve to the OPEN or ON position before
attempting to start the engine.
2. Turn the engine switch to the ON position.
3. Operate the starter.
Turn the engine switch to the START position, and hold it there
until the engine starts.
If the engine fails to start within 5 seconds, release the engine
switch, and wait at least 10 seconds before operating the
starter again.
Using the electric starter for more than 5 seconds at a time will
overheat the starter motor and can damage it.
When the engine starts, release the engine switch.

STOPPING THE ENGINE

To stop the engine in an emergency, simply turn the engine switch
to the OFF position. Under normal conditions, use the following
procedure. Refer to the instructions provided by the equipment
manufacturer.
1. Turn the engine switch to the OFF position.
2. Turn the fuel valve to the CLOSED or OFF position.
4

SERVICING YOUR ENGINE

THE IMPORTANCE OF MAINTENANCE

Good maintenance is essential for safe, economical, and
trouble-free operation. It will also help reduce pollution.
Improper maintenance, or failure to correct a problem
before operation, can cause a malfunction in which
you can be seriously hurt or killed.
Always follow the inspection and maintenance
recommendations and schedules in this owner's
manual.
To help you properly care for your engine, the following pages
include a maintenance schedule, routine inspection procedures, and
simple maintenance procedures using basic hand tools. Other
service tasks that are more difficult, or require special tools, are
best handled by professionals and are normally performed by a
Honda technician or other qualified mechanic.
The maintenance schedule applies to normal operating conditions.
If you operate your engine under severe conditions, such as
sustained high-load or high-temperature operation, or use in
unusually wet or dusty conditions, consult your servicing dealer for
recommendations applicable to your individual needs and use.
Maintenance, replacement, or repair of the emission control
devices and systems may be performed by any engine repair
establishment or individual, using parts that are ''certified'' to EPA
standards.

MAINTENANCE SAFETY

Some of the most important safety precautions follow. However,
we cannot warn you of every conceivable hazard that can arise in
performing maintenance. Only you can decide whether or not you
should perform a given task.
Failure to properly follow maintenance instructions
and precautions can cause you to be seriously hurt or
killed.
Always follow the procedures and precautions in this
owner's manual.
ENGLISH