Thermador Professional Pro Grand Serie Instructions D'installation page 4

Low backguard installation
Tools needed
• T-20 torx head screwdriver or drill
• Protective work gloves
Attach the backguard before sliding the appliance into the
final installed position.
To remove the island trim
1. With a T-20 torx head screwdriver, remove the screws
in the front face of the island trim.
2. Remove the T-20 torx screws securing the trim to the
side panels and the back panel. Lift up to fully remove.
Page. 3
To install the low backguard
1. Align the low backguard with the range side panel's
right and left rear corners. The backguard is inserted
inside the guide channels on the back of the range.
2. The backguard's front face is outside the flange on the
front side of the range.
3. Re-install screws.