Removing Jammed Paper - Toshiba TEC B-450-QP Série Mode D'emploi

11. GENERAL MAINTENANCE

11.3 REMOVING JAMMED PAPER

1. Turn the power off.
2. Open the top cover.
3. Move the head release lever toward the front of the printer to raise the print head block.
4. Remove the ribbon and paper.
5. Remove the jammed paper. DO NOT USE any sharp implement or tool as these could damage the
printer.
6. Clean the print head and platen, then remove any further dust or foreign substances.
Top Cover
7. Paper jams in the cutter unit can be caused by wear or residual glue from label stock on the cutter. Do
not use unspecified paper in the cutter. If frequent jams occur in the cutter contact your Authorised
Service representative.
Cleaning the Cutter Unit
1. Be sure to disconnect the power cord before cleaning the cutter unit.
2. The cutters are sharp and care should be taken not to injure yourself when cleaning.
1. Press the cutter cover release lever to detach the cutter cover.
Cutter Cover
Release Lever
Cutter Cover
WARNING!
E11-3
ENGLISH VERSION EO1-33005
11.3 REMOVING JAMMED PAPER
Print Head Block
Head Release Lever
Fig. 11-4
Fig. 11-5