Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4ft Cross Support and Wire Grid Assembly
(i) Assemble the 4ft cross supports with one 1/4" hex bolt and 1/4" lock nut.
14
(ii) Attach the assembled 4ft cross supports to the perimeter frame with four hex bolts, eight
flat washers, and four lock nuts.
(i) Begin at the side ends of the VersaRac Pro and slide the finishing grid sections with one grid
15
support. End grids have bent edges on one side. For easy install, place the grid supports first
and bend the grid towards the front / back beams (i) and seat it down into position (ii).
(ii)
16
Moving inward, place remaining wire grid supports and grid section onto the VersaRac Pro
18
(ii)
(i)
(i)
Publicité
Table des Matières
