NewAge Products VERSARAC PRO Guide D'installation page 11

Plan the Installation Location
Locate and mark the center of ceiling stud for top ceiling brackets and vertical posts.Use a stud
A
finder to locate the studs if ceiling is finished with drywall.
Plan where the VersaRac Pro would be installed and mark Points A1 and B1 on the center
of a stud, 94.3" or 46.3" apart depending on the orientation which you choose to install the
B
VersaRac Pro. NOTE: Aligning the edge of the VersaRac Pro to the center of the stud is not
required but it is recommended.
A1
94.3"
or
46.3"
B1
Mark two curved lines 94.3" or 46.3" apart from Points A1 and B1 as shown. If 94.3" was
C
measured in step B, then measure 46.3".
NOTE: Refer page 22 if required to install the Stud Hanger.
94.3in or 46.3in
(Use dimension not used in step B )
A1
B1
A1
Stud
B1
11