Publicité
Les langues disponibles
Les langues disponibles
assembly
Bend the side walls of the upper air duct slightly outwards
and clamp the flanged rim of the upper air duct to the
attachment bracket.
Clamp the lower air duct to the upper air duct and lower the
air duct onto the extractor hood.
Make the plug connection in the extractor hood.
click!
Attention! The plug connection must click tight.
Fit the filters (see Page 6) and test the functioning of the
hood.
GB 12
assembly
suspend the hood
model WS90..B
2
Slide the protective plate over the motor module (1) in such a
way that the grooves on the rear of the protective plate are
on top of the motor unit.
1
Secure the protective plate on the top with
four tapping screws (2).
Slide the flexible discharge hose onto the motor module.
Fit the hood to the motor module. First hang the rear of the
hood in the motor module from below (1).
3
Then tilt the front upwards (2), so that the two M5 x 12 bolts
1
supplied can be screwed in (3).
2
Make the hood level with these bolts.
GB 13
Publicité
