Roger Technology H70/104AC Instructions Et Consignes Pour L'installateur page 62

14
DISPLAY POSSIBLE CAUSE
(Sb)
Sensing edge
Sensing edge
Photocell FT1 not connected or Set the parameter
Photocell FT2 not connected or Set the parameter
Both limit switches in open con-
Gate is at gate closed limit If the limit switch state indicated
Gate open limit switch absent or -
Gate is at gate closed limit If the limit switch state indicated
Gate closed limit switch absent
If occurs with no voluntary com-
If occurs with no voluntary com-
N.B.: Press TEST
62
ACTION BY SOFTWARE
COS1 not con- Set the parameter
used or to disable
COS2 not con- Set the parameter
used or to disable
if not used or to disable
if not used or to disable
parameter
parameter
-
TEST
PHYSICAL CORRECTIVE
Close the release handle and turn
-
Check that the release contact is
Install a STOP
-
COM
if not Jumper contact COS1 with con-
tact COM, if not used or to dis-
able
if not Jumper contact COS2 with con-
tact COM, if not used or to dis-
able
e Jumper contact FT1 with contact
COM
e Jumper contact FT2 with contact
COM
-
-
-
-
Check PP - COM contacts and
-
Check CH - COM contacts and
-
Check AP - COM contacts and
-
Check PED - COM contacts and
-
Check ORO - COM
-
ACTION
ST contact with the
-
-
-