Roger Technology H70/104AC Instructions Et Consignes Pour L'installateur page 41

COMMAND STATUS
AP PED
PP
CH ORO
POWER ENC
TEST mode
gate has reached the gate open limit switch
NOTA
SAFETY DEVICE STATUS
FT1 FT2
COS1
COS2
SB STOP
The status of the safety devices/inputs is shown on the right hand
or gate closed limit switch
(Sb)
COMMAND STATUS:
The command status indicators on the display
(segments AP = open, PP = step mode, CH = close,
, ORO= clock) are normally
SAFETY DEVICE STATUS:
The safety device status indicators on the display
(segments FT1/FT2=photocells,
sensing edge FCA= gate open limit switches,
or is shown on the display to indicate that the
No safety device in alarm state, and no limit
STOP
Sensing edge COS1
Sensing edge COS2
Photocell FT1
Photocell FT2
Gate completely open / Gate open limit switch
Gate completely closed / Gate closed limit switch
COS1/COS2 =
are normally
41