BBG M3 Manuel De Service Et De Maintenance page 20

To assemble reverse the procedure described under "Stripping".
Clean all parts carefully and check for damage.
-
Replace damaged parts with original spares.
-
Lightly lubricate all parts before reassembling.
-
Only trained personnel should reassemble the hammer.
-
Reassemble as shown in enclosed drawing or spare parts list.
-
Before start-up tighten all screw connections.
-
Check safety components.
-
Failure to do this could lead to loosening of the handle and resultant injury!!
Before inserting the steel grease shank end with Molycote.
-
Never switch on the machine without previously inserting the steel as the vibration caused by idle
-
blows of the piston could lead to injury.
- 18 -
ASSEMBLY
ATTENTION