Rocal Giselle 90 Manuel Des Caracteristiques, Installation Et Fonctionnement page 11

4. Poor heating
5. Venting smoke and / or
gases from the front, bad
smell
6. Excessive draft
7. Poor draft
7. CE INFORMATION
The CE label is located on the appliance. This label contains technical data and OF number. (This number can also be found in
the guarantee).
THIS NUMBER IS ESSENTIALFOR ORDERING SPARE PARTS.
CAUTION:
- All tests are carried out in observance of Regulations
UNE-EN13240:2002-A2:2005-AC: 2006-A2:2005/AC: 2007 "Stoves that use solid fuels – Requirements and test
methods".
- The review of the equipment, the installation and ducts must be carried out by a professional.
- In case of doubt regarding the described herein, please contact your Rocal dealer.
- FAILURE TO COMPLY WITH THE OBLIGATIONS DESCRIBED HEREIN OR IMPROPER HANDLING OF THE
EQUIPMENT SHALL EXONERATE THE MANUFACTURER OF ANY LIABILITY.
Inappropriate fuel
Insufficient load
Combustion control registers in the wrong
position
First lighting
Flammable or combustible items in the
enclosure or surrounding
equipment
Crack in the combustion chamber of the
equipment
Incorrect duct
Combustion control registers in the wrong
position
Incorrect duct
Duct dirtiness
Use recommended fuel
Adding fuel
Adjust registers
Wait for the polymerization process of the paint to
finish; this can take from one to several lightings.
Review of insulating materials such as fiberglass,
fireproof wood or any inflammable elements and
walls of the replace them.
Check for tightness and if you discover a crack,
please contact your dealer.
Duct servicing
- Excessive length
- Check Depression
- Incorrect diameter
- Check door gasket
Open the primary and secondary register following
the steps outlined in the manual. Should this not
have an effect, check that the flue duct is clean; if it
is not clean, contact a professional to clean this. If
the problem persists contact your dealer.
10