Rocal RCr Serie Manuel Des Caracteristiques, Installation Et Fonctionnement page 20

4.4. Use and maintenance. The set of ventilation should be permanently connected to the grid when
the device is switched on.
The switch offers three positions (C-25):
- Position 0: Slow gear. The starting and stoppage of the turbines is through the automatic thermostat.
- Position I: Slow gear. Manually (manual, not automatic shutdown system)
- Position II: Fast gear. Manually (manual, not automatic shutdown system)
After a period of prolonged and stop before putting the machine in motion, it is necessary to verify the
proper operation of the turbines and cleaned all the dirt of the front grilles of the air intake. It is also
desirable that a qualified professional review the entire electrical installation of the device.
WARNING:
If the feeding wires are damaged, they must be replaced either by the manufacturers (returning
the apparatus to the factory), sales department or qualified staff to avoid problems.
5. REMOVING THE ELECTRICAL SYSTEM
The electrical assembly is installed to insert, but for possible replacements, can be removed.
To do this follow these steps:
5.1. DISCONNECT THE APPLIANCE THE ELECTRICAL NETWORK.
5.2. Fan location (E-1). On both sides of the ash tray find the grids, behind these grids you can find a
fans. To access them you must first remove the protector of fans unscrewing the screws that hold it
and then you can remove the fan tilting first and then pulling them out (E-2).
5.3. Electrical system components. When the fans removed will have access to the interior and from
there locate the electrical system components such us the thermostat (E-3) (located on the right side,
below the fire grate, is attached by some tabs to remove it must release these tabs), resistance,
electrical wiring or switch.
From manufacturing, the electrical system outlet on the right side out, but if you wish, you can change
on the opposite side by removing the electrical power cord from the left side.
6. DOOR OPENING CHANGE
This appliance has to change the direction of opening the door (standard is from right to left), to do the
following steps:
6.1. Removing the door (F-1, F-2). To remove the door, you must first open it and lift it slightly until it
stops up, pull it out to release the bottom bracket and then drop it until it is released from the top
bracket.
6.2. Remove handle and stop (F-3). Unscrew the screws holding the handle and the top of the handle
of the door.
6.3. Glass side mounting support (F-4). Unscrew the screw holding the bracket side fixing glass.
6.4. Upper fixing support the glass (F-5, F-6 ). Unscrew the bolts holding the upper
for Graffiti models
attachment of the support of glass.
6.5. Glass support (F-7, F-8 ). Remove the glass support.
for Graffiti models
6.6. Glass (F-9, F-10 ). Remove with caution, glass.
for Graffiti models
6.7. Support handle (F-11). Remove the handle support.
6.8. Side support frame the glass (F-12). Remove part of the support frame of the door glass.
6.9. Door hinges. Finally you must remove parts of the mechanism of the door hinges.
After removing all the door to change the door opening, you must put back the pieces following these
steps in reverse and the opposite side they were.
Pag. 19