Pre-Operation Checks; Before Starting The Engine - Powerfist GAS WATER PUMP Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

V1.0
SUCTION HOSE SETUP
1.
Connect a non-collapsible
suction hose to the pump's
inlet. This hose should be no
longer than 26 feet long.
2.
Attach the strainer basket to
the other end of the suction
hose by inserting the adapter
to the hose end.
3.
Fix with a hose clamp.
DISCHARGE HOSE SETUP
A discharge hose is optional, as the pumping force will propel the water away.
However, the discharge is uncontrolled. Adding a discharge hose will guide the
water to a specific location. The hose diameter must be larger than the pump's
discharge port size.
1.
Connect a hose to the pump's outlet (C). See Specifications for the Max.
Discharge Head hose length.
2.
Fix the end of the discharge hose to prevent it from moving around due to
the force of the discharge.
OPERATION

PRE-OPERATION CHECKS

NOTICE! The engine is not shipped with oil. Before starting the engine, add oil
according to the instructions in this manual. Starting the engine without oil
will damage the engine beyond repair.
Check the engine's condition before operating to maximize the user's safety
and the service life of the engine. Ensure that the engine is level and the switch
is in the OFF position before beginning the pre-operation checks.

BEFORE STARTING THE ENGINE

WARNING! Do not start or run engine in an enclosed area, even if the doors or
windows are open. Engine exhaust contains carbon monoxide (see Carbon
Monoxide Precautions).
1.
Make sure spark plug, muffler, fuel cap and air filter are in place and secured.
2.
Ensure the spark plug lead is securely connected to the spark plug, otherwise
unintentional sparking can result, causing a fire or electric shock.
Visit www.princessauto.com for more information
2 in. Gas Water Pump
8887200
Fig. 4
Fig. 5
9

Publicité

Table des Matières
loading

Table des Matières