Powerfist GAS WATER PUMP Mode D'emploi page 5

V1.0
4. The pump is non-submersible. Keep the engine dry at all times. Protect the
engine from wet weather.
5. Operate water pump from a stable surface.
6. Anchor the pump to avoid equipment movement. The load from hoses may
cause the pump to tip over.
7. Do not pump the following to avoid creating a hazardous situation or
damaging the pump:
a. Flammable liquids such as fuel or fuel oils.
b. Hot liquids. This will overheat the pump and the thermal protection
system will shut the pump off until it has cooled.
c. Sea water, beverages, acids, chemical solutions or any other liquid
that promotes corrosion can damage the pump.
8. Do not run the pump dry. This will cause cavitation in the pump
mechanism and can damage the pump beyond repair.
9. Do not obstruct the suction or discharge hose in any way.
10. Never operate pump without a strainer basket connected to the end of the
suction hose.
11. Never run the pump against a closed discharge. The pump may overheat,
damaging the seals and creating a situation where a burn injury can
result. Prime the pump with water before starting.
12. Do not allow the pump or any other system component to freeze, as this
can damage the pump during operation.
13. Never move machine by pulling on the hoses. Hold the unit's frame when
moving it.
14. This water pump is not for use in mobile equipment or marine
applications.
ENGINE PRECAUTIONS
1. All users must understand the operation of all controls and learn how to
stop the engine quickly in case of emergency.
2. Do not tamper with governor spring, links or other engine parts to
increase speed or power.
3. The engine and exhaust become very hot during operation. Severe thermal
burns can occur on contact, especially with the muffler.
Visit www.princessauto.com for more information
Gas Water Pump 8887200
5