Powerfist GAS WATER PUMP Mode D'emploi page 21

V1.0
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing uncontrolled
discharge of waste oil.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
PROBLEM(S) POSSIBLE CAUSE(S)
Engine will not 1. Engine is cold.
start.
2. Fuel valve in OFF position.
3. Engine switch is in OFF position
4. Engine oil is low.
5. Out of fuel.
6. Bad fuel, engine stored without
7. Engine is flooded
8. Spark plug fouled/fails to
9. Fuel filter restricted, carburetor
Visit www.princessauto.com for more information
2 in. Gas Water Pump
treating or draining gasoline or
refueled with bad gasoline
produce a spark.
malfunction, ignition
malfunction, valves stuck, etc.
SUGGESTED SOLUTION(S)
1. Move choke to CLOSED position
until warm, then move to the
OPEN position.
2. Move to ON position
3. Move to ON position
4. Fill with the recommended oil to
the proper level.
5. Refuel
6. Drain fuel tank and carburetor.
Refuel with fresh gasoline.
7. Move choke to OPEN/RUN
position and attempt to start the
engine.
8. Remove and clean spark plug.
Check electrode spacing and set
the gap to the correct
dimension. Replace spark plug if
damaged. Ensure the spark plug
lead is installed and connected.
9. Replace or repair faulty
components as needed. Contact
Princess Auto Ltd or take engine
to an authorized service center
if necessary.
8887200
21