Powerfist GAS WATER PUMP Mode D'emploi page 15

V1.0
DRAIN AND FLUSH WATER PUMP
1. Disconnect and drain the suction and discharge hoses.
2. Remove the drain plug at pump's bottom (Fig. 14).
3. Remove the primer plug from top of pump and flush the pump's internal
components with clean water (Fig. 15).
4. Replace both plugs and finger tighten.
HOW TO ADD FUEL
DANGER! Fuel is very flammable. Use extreme care when handling or storing
fuel. An ignition source contacting the fumes or fuel may result in a fire or
explosion and cause fatal or serious injuries to you or a bystander.
1. Refuel outdoors or in a well-ventilated area and immediately wipe up
spills. Fuel can damage paint and plastic.
2. Stop the engine and position equipment on a level surface.
3. Let engine cool at least 2 minutes before removing the fuel cap.
4. Clean the fuel cap area of dirt and debris. Do not allow dirt or water to
enter the fuel tank.
5. Remove the fuel cap slowly to allow the pressure to equalize.
6. Check the fuel level.
7. Add fuel until it reaches the
bottom of the fuel level
limit marked in the fuel
tank. Take care to not
overfill the tank. It may be
necessary to lower the fuel
level depending on
operating conditions
(Fig. 16-1).
8. Reinsert the fuel tank cap and tighten.
Visit www.princessauto.com for more information
2 in. Gas Water Pump
Fig. 14
8887200
Fig. 15
16-1
Fig. 16
15