Start The Engine - Powerfist GAS WATER PUMP Mode D'emploi

8887200

START THE ENGINE

WARNING! Failure to follow the steps below will result in rapid retraction of the
starter cord faster than the user can let go. This will pull the user's hand and
arm toward the engine, possibly resulting in serious injury.
1. Ensure spark plug, muffler, fuel cap and air filter are in place. Do not crank
engine with spark plug removed.
2. Move the fuel valve lever to
the ON position (Fig. 9-1).
When the valve lever is in the
ON position, fuel is allowed to
flow from the fuel tank to the
carburetor.
3. Push the switch to the ON
position (Fig. 10-1).
4. Move the throttle lever to the
FAST position (Fig. 10-2).
5. Move the choke lever to the
CLOSED position (Fig. 11-1). The
choke is used to provide an
enriched fuel mixture when
starting a cold engine. It can be
opened and closed by operating
the choke lever manually. The choke
is usually unnecessary when restarting a warm engine.
6. Pull Start
a. Pull the recoil starter handle lightly until you feel resistance.
b. Pull the recoil starter handle briskly as soon as resistance is felt.
c. Do not allow the recoil starter handle to snap back against the
engine. Instead, return the starter grip gently by hand.
7. The engine should turn over and start running. If engine floods, set the
choke lever to the OPEN position, place the throttle in FAST and crank until
engine starts.
8. If the choke lever was moved to the CLOSED position to start the engine,
gradually move it to the OPEN position as the engine warms up.
Occasionally you may hear a light 'spark knock' or 'pinging' (metallic rapping
noise) while operating under heavy loads. This is no cause for concern.
12
2 in. Gas Water Pump
For technical questions call 1-800-665-8685
V1.0
Fig. 9
Fig. 10
Fig. 11