Auto Pause And Pour Feature - Melita Fast Brew MEFB6B Mode D'emploi

Auto Pause and Pour Feature

The Auto Pause and Pour feature allows you to pour a cup of coffee or
tea before brewing is complete. Simply remove the Carafe from the
Warming Plate. Always keep the Lid on the Carafe down when pouring
the coffee.
IMPORTANT: When using the Auto Pause and Pour feature while the
Coffee Maker is still brewing, the Carafe must be replaced on the
Warming Plate, under the Filter Holder Cavity within 30 seconds to pre-
vent the Filter Holder from overflowing.
Replacing the Carafe will restart the brew-
ing process.
Brew Strength Feature
Use the Brew Strength feature to control
the desired strength of your coffee or tea.
This feature regulates the flow of water to
either slow down or speed up the brewing
process depending on the strength you
desire. Simply adjust the Brew Strength
Control on the top of the lid before start-
ing each brew cycle to achieve desired
strength.
FIGURE 3:
Brew Strength Control
To Brew a Second Pot of Coffee or Tea
To brew a second pot of coffee or tea, turn the appliance OFF for
10 minutes and allow it to cool. Empty used coffee grounds or loose leaf
tea / tea bags and repeat steps for brewing.
CAUTION: Failure to allow appliance to cool completely may cause
water to overheat and spray hot steam. The hot steam can cause
severe burns.
14