Frothing Milk - MPM MKW-08M Manuel De L'utilisateur

ATTENTION! The portafilter, filter baskets and group head are hot. Proceed with care to avoid scalding. Always
hold the portafilter by the handle. Regularly empty the drip tray.
ATTENTION! Regularly control the quantity of water in the tank. Do not allow the espresso machine to operate
without water. Do not remove the water tank while operating the espresso machine.
ATTENTION! The espresso machine is equipped with an automatic deactivation function after 30 minutes of
operation.

FROTHING MILK

The milk frothing feature helps make milk froth or heat milk for the coffee. The milk is frothed
with a jet of hot steam forced under pressure from the steam jet nozzle (14). Make your coffee
first, then process the milk.
CAUTION! The released steam jet is hot. Handle with care. Risk of burns!
1. Swivel the steam jet nozzle to the right of the espresso machine by handling the steam jet
rubber sleeve (15), as shown in Fig. 3. This way the nozzle can be easily put in the container
with milk.
2. Turn on the steaming switch (2d) and wait until its LED is
steadily on. Now, hot steam is ready.
CAUTION! The water heater is automatically turned off when the steam
heater is running. This is to provide more heat for the steam.
3. Place an empty container under the nozzle (14) and gen-
tly turn the steam level knob (4) to the left to vent residu-
al water from the nozzle. The nozzle will blow steam with
water droplets, followed by steam only. Turn the steam level
knob (4) off, to the uppermost position 0.
CAUTION! The steam jet nozzle (14) has a guard (16). The guard (16) must
be installed on the nozzle when in use. Risk of burns!
4. Put the container with milk under the nozzle (14) and im-
merse the nozzle tip in the milk. Now, gradually increase the steam level with the knob (4)
while gently swirling the milk in the container. Gradually immerse the nozzle deeper in the
milk. Do not froth milk longer than one minute at a time.
5. When milk frothing is complete, turn steam heating off by pressing the (2d) button. When
heating is off, the (2b) and (2c) button indicators are flashing quickly, indicating that the
temperature is too high for another brewing process. Wait until the espresso machine cools
down (the indicators have illuminated solid) before next brewing. You can speed up the cool-
ing process by releasing some steam into a dish placed under the nozzle. After use, turn the
appliance off by pressing the (2a) button, unplug it, wait until cooled down, and clean.
CAUTION! Before unplugging from the mains, place a container with water under the steam jet nozzle, immerse
it in the water, and flush the nozzle and its guard clean. This will prevent persistent milk stains.
F i g . 3
17