Renkforce 1192999 Notice D'emploi page 29

(8) PITCH slider
Use the PITCH slider to change the playback speed.
Pull the slider down to increase the playback speed.
Push the slider up to decrease the playback speed.
The current change is shown as a percentage on the display.
Leave the slider in the middle position to effect no change in the playback speed.
The slider only has an effect when the pitch function has been activated using the PITCH
button (9).
(9) PITCH button
Use this button to activate/deactivate and control the PITCH slider (8) PITCH function.
Briefly push the PITCH button to adjust the pitch range of the PITCH slider (8). 3 LEDs beneath the PITCH
slider (8) display the pitch range. Adjustable pitch ranges are +/-4/8/16 %.
Push and hold the PITCH button for approx. 3 seconds to select the desired pitch function:
Button lights up > pitch function deactivated
Button lights up > pitch function activated
Button flashes > pitch function with master tempo is activated
The master tempo function allows the user to control the playback speed without effecting the
tone pitch as is the case with the normal pitch function.
(10) RELOOP button
Use this button to reload a saved playback loop.
You can find a detailed description of the LOOP function under „LOOP function (playback loop)"
in the following chapter of this user manual.
(11) OUT button
The device allows you to save a seamless playback loop (LOOP). To use this function, the device features
the buttons IN (12), OUT (11) and RELOOP (10).
Use the OUT button to program the endpoint for the playback loop or push the button again to leave the
playback loop.
You can find a detailed description of the LOOP function under „LOOP function (playback loop)"
in the following chapter of this user manual.
29