Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes; 3-Button Remotes - Chamberlain LiftMaster Elite Serie Manuel D'instructions

PROGRAMMING

NOTICE: If this Security ✚
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚

To Add or Reprogram a Hand-held Remote Control

USING THE "LEARN" BUTTON
1. Press and release the "learn" button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote
you wish to operate your garage door.
3. Release the button when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or keyless
entry you wish to use.
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in
* that
USING THE SMART CONTROL PANEL™
9 1 9 1
7 3 7
5 5 3
KG KG
1. Press the Prog <Learn> button on the
Smart Control Panel™.
2. Press the Prog <Learn> button again to
confirm Learn Mode.
3. Press the button on the hand-held
remote that you wish to operate your
garage door.
4. When the motor unit lights blink, it has
learned the code. If light bulbs are not
installed, two clicks will be heard.
If provided with your garage door opener, the large button
is factory programmed to operate it. Additional buttons on
any Security✚
remote or compact
remote can be
programmed to operate
other Security✚
door openers.
33
® remote controls.

*3-Button Remotes

®
3-Button
®
garage
LO C
K
LI G
H T
L IG H T
K
L O C
T
L IG H
K
L O C